Similar to the Single Arm Spinner, except the pivot is off center and on the backside of the plate the top and bottom target are all one piece. With this pivot location it is a bit more challenging to get a complete revolution. It still has an 8" round on top and 10" round on bottom and approximately 36" top to bottom on the plate. Still a great reactive training tool or competition piece.
The Dueling Tree is a favorite on any steel range. Use it for friendly competition, deciding who buys lunch, dinner, drinks, etc. It stands approximately 5' tall and has a 3' square base that the upright slip-fits into, along with six 3/8"X6" paddles. Add the AR500 reinforcement kit to the upright for $80.
Just like our Dueling Tree except with FOUR paddles, a 2' square base and it stands approximately 3-1/2' tall. Add the AR500 reinforcement kit to the upright for $60.
This is a smaller version of the propeller rack you may have seen. The 3/8"X8" plates are held in place by springs and as they are shot and fall off, the rack becomes unbalanced and spins from the center of the rack. The plates and rack are cut from 3/8" AR500. BUILT TO ORDER.
The goal here, get one complete revolution of the arm as quickly as possible by alternating engagement of the top 8" target and the bottom 10" target. Each top and bottom arm is one piece with the 8" and 10" plates. The system sets up and breaks down for easy storage and transport.
Just like the single arm spinner except there are two sets of arms with two 8" targets on top and two 10" targets on bottom. BUILT TO ORDER.
You may know this target by another name, like whirly something or a name that starts with the largest state in the 48 contiguous. The 8" plates, arms and arm support hub are cut from 3/8" AR500. BUILT TO ORDER.
Everything on this one spins. As a plate is knocked off, the side the plate came off spins and the entire cross assembly spins on the center axle. STILL IN TESTING FOR PISTOL CALIBERS ONLY!
CALL OR TEXT TO ORDER 602-527-0887